New 2022 Realistic DES-5221 Dumps Test Engine Exam Questions in here [Q32-Q54]

QUESTION 32
What is the default lease time in hours for an address lease in DHCP?

QUESTION 33
Which LSA type contains information about routes redistributed into OSPF?

QUESTION 34
When implementing QoS on a 10Gb connection, 6Gb is required by the customer. What QoS level best fits the requirement while keeping resource use to a minimum?

QUESTION 35
What is a valid OS10 iBGP configuration?

QUESTION 36
Which LSA type provides information necessary to reach routers originating type 5 LSA’s in other areas?

QUESTION 37
Which commands are required to properly configure an OS10 switch to run OSPF on eth1/1/3 and to add network 144.254.1.0/30 to OSPF area 0?

QUESTION 38
What version of IGMP is required by PIM-SSM receivers?

QUESTION 39
Refer to the exhibit.

What is the VRRP state of OS10-A after a router with a default VRRP admin priority with VRID100 comes online?

QUESTION 40
Refer to the exhibit.

Which configuration will allow S1 to ping S2’s Lo0 address?

QUESTION 41
A network administrator is designing a Layer 2 topology and requires separate spanning-tree roots to avoid having a given port blocked for all instances. Which spanning-tree protocols will meet this need?

QUESTION 42
Which command shows whether a LAG protocol is static or dynamic on a Dell EMC Networking OS10 switch?

QUESTION 43
How are ACLs processed?

QUESTION 44
A network administrator wants servers to avoid spanning-tree convergence immediately after connecting to a leaf switch. Which spanning-tree feature would allow this?

QUESTION 45
What is the default PIM-SSM IP range?

QUESTION 46
When creating an alias in OS10 what is the maximum number of variable input parameters that can be defined?

QUESTION 47
What is a valid OS10 iBGP configuration?

QUESTION 48

Refer to the exhibit.
Which configuration will allow S1 to ping S2’s Lo0 address?

QUESTION 49
Two OS10 switches reside within a VLT domain with statically configured primary-priorities. The current primary peer, switch OS10-A, has a priority of 100, while the secondary peer, OS10-B, has a priority of 200.
If OS10-A reboots and comes back online, what roles will the VLT peers be assigned?

QUESTION 50
A customer reports they can no longer access their services and a network administrator has been assigned to investigate. A UFD disabled error status appears on all ports. What caused the issue?

QUESTION 51
When installing OS10 on a switch from a USB drive, what format is used for the file system?

QUESTION 52
Refer to the exhibit.

The output shown is from which command?

QUESTION 53
A customer has disabled LLDP on the management interface of the switch. What is the proper command to re- enable it?

QUESTION 54
When creating an alias in OS10 what is the maximum number of variable input parameters that can be defined?