[Feb 19, 2023] Genuine NSE7_SDW-6.4 Exam Dumps Free Demo [Q33-Q56] : Free Exams Dumps Materials : http://exams.dumpsmaterials.com

QUESTION 33
Refer to the exhibit.

Based on the exhibit, which status description is correct?

Port1 is dead because it does not meet the SLA target.

Port2 is alive because its packet loss is lower than 10%.

The SD-WAN members are monitored by different performance SLAs.

Traffic matching the SD-WAN rule is steered through port2.

QUESTION 34
Refer to exhibits.

Exhibit A shows the performance SLA exhibit B shows the SD-WAN diagnostics output.
Based on the exhibits, which statement is correct?

Both SD-WAN member interfaces have used separate SLA targets.

The SLA state of port1 is dead after five unanswered requests by the SLA servers.

Port1 became dead 1ecause no traffic was offload through the egress of port1.

SD-WAN member interfaces are affected by the SLA state of the inactive interface

QUESTION 35
Refer to the exhibit.

What must you configure to enable ADVPN?

On the hub VPN, only the device needs additional phase one sett

ADVPN should only be enabled on unmanaged FortiGate devices.

Each VPN device has a unique pre-shared key configured separately on phase one

The protected subnets should be set to address object to all (0.0 .0. o/o).

QUESTION 36
Which three parameters are available to configure SD-WAN rules? (Choose three.)

Application signatures

Type of physical link connection

URL categories

Source and destination IP address

Internet service database (ISDB) address object

QUESTION 37
Which diagnostic command can you use to show interface-specific SLA logs for the last 10 minutes?

diagnose sys sdwan log

diagnose sys sdwan health-check

diagnose sys sdwan intf-sla-log

diagnose sys sdwan sla-log

QUESTION 38
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two )

It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links.

It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance.

It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub.

It provides direct connectivity between all sites by creating on-demand tunnels between spokes.

QUESTION 39
Refer to exhibits.

Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?

Create a new firewall policy, and the select the SD-WAN zone as Incoming Interface.

In the traffic shaping policy, select Assign Shaping Class ID as Action.

In the firewall policy, select Proxy-based as Inspection Mode.

In the traffic shaping policy, enable Reverse shaper, and then select the traffic shaper to use.

QUESTION 40
Refer to the exhibits.
Exhibit A:

Exhibit B:

Exhibit A shows the SD-WAN rules and exhibit B shows the traffic logs. The SD-WAN traffic logs reflect how FortiGate distributes traffic.
Based on the exhibits, what are two expected behaviors when FortiGate processes SD-WAN traffic? (Choose two.)

The first Vimeo session may not match the Vimeo SD-WAN rule because the session is used for the application learning phase.

The implicit rule overrides all other rules because parameters widely cover sources and destinations.

The Vimeo SD-WAN rule steers Vimeo application traffic among all SD-WAN member interfaces.

SD-WAN rules are evaluated in the same way as firewall policies: from top to bottom.

QUESTION 41
In which two ways does FortiGate learn the FortiManager IP address or FQDN for zero-touch provisioning? (Choose two.)

From a FortiGuard definitions update

From the central management configuration configured in FortiDeploy

From a DHCP server configured with options 240 or 241

From another FortiGate device in the same local network

QUESTION 42
Refer to the exhibit.

Which statement about the command route-tag in the SD-WAN rule is true?

It enables the SD-WAN rule to load balance and assign traffic with a route tag

It tags each route and references the tag in the routing table.

It uses route tags for a BGP community and assigns the SD-WAN rules with same tag.

It ensures route tags match the SD-WAN rule based on the rule order

QUESTION 43
Refer to the exhibit.

Based on the exhibit, which statement about FortiGate re-evaluating traffic is true?

The type of traffic defined and allowed on firewall policy ID 1 is UDP.

FortiGate has terminated the session after a change on policy ID 1.

Changes have been made on firewall policy ID 1 on FortiGate.

Firewall policy ID 1 has source NAT disabled.

QUESTION 44
Which two statements reflect the benefits of implementing the ADVPN solution to replace conventional VPN topologies? (Choose two )

It dynamically assigns cost and weight between the hub and the spokes, based on the physical distance

It creates redundant tunnels between hub-and-spokes, in case failure takes place on the primary links

It ensures that spoke-to-spoke traffic no longer needs to flow through the tunnels through the hub

It provides direct connectivity between all sites by creating on-demand tunnels between spokes.

QUESTION 45
Which components make up the secure SD-WAN solution?

Application, antivirus, and URL, and SSL inspection

Datacenter, branch offices, and public cloud

FortiGate, FortiManager, FortiAnalyzer, and FortiDeploy

Telephone, ISDN, and telecom network.

QUESTION 46
Refer to exhibits.

Exhibit A shows the firewall policy and exhibit B shows the traffic shaping policy.
The traffic shaping policy is being applied to all outbound traffic; however, inbound traffic is not being evaluated by the shaping policy.
Based on the exhibits, what configuration change must be made in which policy so that traffic shaping can be applied to inbound traffic?

The reverse shaper option must be enabled and a traffic shaper must be selected

The guaranteed-10mbps option must be selected as the reverse shaper option.

A new firewall policy must be created and SD-WAN must be selected as the incoming interface.

The guaranteed-10mbps option must be selected as the per-IP shaper option

QUESTION 47
Which diagnostic command can you use to show the SD-WAN rules interface information and state?

diagnose sys virtual-wan-link neighbor.

diagnose sys virtual-wan-link route-tag-list

diagnose sys virtual-wan-link member.

diagnose sys virtual-wan-link service

QUESTION 48
When attempting to establish an IPsec tunnel to FortiGate, all remote users match the FIRST_VPN IPsec VPN. This includes remote users that want to connect to the SECOND_VPN IPsec VPN. Which two configuration changes must you make on both IPsec VPNs so that remote users can connect to their intended IPsec VPN? (Choose two.)

Configure different proposals.

Configure a unique peer ID.

Configure different Diffie Hellman groups.

Change the IKE mode to aggressive.

QUESTION 49
Refer to the exhibit.

Which two statements about the status of the VPN tunnel are true? <Choose two )

There are separate virtual interfaces for each dial-up client.

VPN static routes are prevented from populating the FortiGate routing table.

FortiGate created a single IPsec virtual interface that is shared by all clients.

100.64.3.1 is one of the remote IP address that comes through index interface 1.

QUESTION 50
Which action FortiGate performs on traffic that is subject to a per-IP traffic shaper of 10 Mbps?

FortiGate shares 10 Mbps of bandwidth equally among all source IP addresses.

FortiGate applies traffic shaping to the original traffic direction only.

FortiGate limits each source IP address to a maximum bandwidth of 10 Mbps.

FortiGate guarantees a minimum of 10 Mbps of bandwidth to each source IP address.

QUESTION 51
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the traffic shaping policy and exhibit B show: the firewall policy FortiGate is not performing traffic shaping as expected basi on the policies shown in the exhibits.
To correct this traffic shaping issue on FortiGate, what configuration change must be made on which policy?

The shaper mode must be applied per-IP shaper on the traffic shaping policy

The application control profile must be enabled on the firewall policy.

The web filter profile must be enabled on the firewall policy

The URL category must be specified on the traffic shaping policy

QUESTION 52
Which CLI command do you use to perform real-time troubleshooting for ADVPN on either a hub or a spoke FortiGate?

diagnose sys virtual-wan-link service

get router info routing-table

diagnose debug application ike

get ipsec tunnel list

QUESTION 53
Refer to the exhibit.
Multiple IPsec VPNs are formed between two hub-and-spokes groups, and site-to-site between Hub 1 and Hub 2 The administrator configured ADVPN on the dual regions topology

Which two statements are correct if a user in Toronto sends traffic to London? (Choose two )

Toronto needs to establish a site-to-site tunnel with Hub 2 to bypass Hub 1.

The first packets from Toronto to London are routed through Hub 1 then to Hub 2.

Traffic from Toronto to London triggers the dynamic negotiation of a direct site-to-site VPN

London generates an IKE information message that contains the Toronto public IP address

QUESTION 54
Refer to exhibits.
Exhibit A.

Exhibit B.

Exhibit A shows the SD-WAN performance SLA and exhibit B shows the SO-WAN interface and the static routes configuration.
Port1 and port2 are member interfaces of the SD-WAN, and port2 becomes a dead member after reaching the failure thresholds Which statement about the dead member is correct?

Subnets 100 .64.1.0/23 and 172 . 20 . 0. 0/16 are reachable only through port1

SD-WAN interface becomes disabled and port1 becomes the WAN interface

Dead members require manual administrator access to bring them back alive

Port2 might become alive when a single response is received from an SLA server

QUESTION 55
What are the two minimum configuration requirements for an outgoing interface to be selected once the SD-WAN logical interface is enabled? (Choose two )

Specify outgoing interface routing cost.

Configure SD-WAN rules interface preference.

Select SD-WAN balancing strategy.

Specify incoming interfaces in SD-WAN rules.

QUESTION 56
Which statement is correct about the SD-WAN and ADVPN?

ADVPN interface can be a member of SD-WAN interface.

Dynamic VPN is not supported as an SD-Wan interface.

Spoke support dynamic VPN as a static interface.

Hub FortiGate is limited to use ADVPN as SD-WAN member interface.

[Feb 19, 2023] Genuine NSE7_SDW-6.4 Exam Dumps Free Demo [Q33-Q56]

Fortinet NSE7_SDW-6.4 Exam Syllabus Topics: