Cisco 010-151 Practice Exam - 169 Unique Questions [Q74-Q96] : Free Exams Dumps Materials : http://exams.dumpsmaterials.com

NO.74 Refer to the exhibit.

Which three options are features of the Cisco UCS 6248UP Fabric Interconnect front panel? (Choose three.)

Console port

FCoE port

10 Gb/s port

Fan module

USB port

NO.75 DRAG DROP

NO.76 Which two statements about PCIe are true? (Choose two.)

The PCIe link is built around dedicated unidirectional couples of serial, point-to-point connections known as lanes.

You can install a PCI Express x8 adapter into an x4 slot.

The PCIe standard is a bus-based system in which all the devices share the same bidirectional, 32-bit or
64-bit, parallel signal path.

The PCIe 1.0 standard doubles the transfer rate compared to PCIe 2.0.

A link that is composed of four lanes is called an x4 link.

NO.77 Which two statements about the Ethernet media are true? (Choose two.)

A twisted-pair cable system has each pair of wires twisted together to reduce electromagnetic interference.

Compared to multimode fiber, the single-mode fiber is designed for shorter distances with higher cost.

40 Gigabit Ethernet twinax cables deploy Enhanced Quad Small Form Factor Pluggable (QSFP+) connectors.

The twinax cables can be found in either a shielded twisted-pair or an unshielded twisted-pair variation.

A passive twinax cable can carry an Ethernet signal over 5m.

NO.78 Which method is a TCP/IP-based protocol for establishing and managing connections between IP-based storage devices, hosts, and clients?

FCIP

iFCP

iSCSI

FCoE

NO.79 On the Sensors page from the CIMC view, which four tabs are displayed to view further information? (Choose four.)

Power Supply

Fan

Memory

CPU

LEDs

Temperature

NO.80 Which device provides analysis of Fibre Channel traffic without any network disruption?

Cisco MDS 9000 Data Analyzer Adapter

Cisco MDS 9000 Port Analyzer Adapter

Cisco MDS 9000 Channel Analyzer Device

Cisco MDS 9000 Channel Analyzer Adapter

NO.81 Refer to the exhibit.

Which item does A represent?

Emulex Adapter Card for Cisco UCS B420 M3 Blade Servers

Virtual Interface Card for Cisco UCS B420 M3 Blade Servers

mLOM for Cisco UCS B420 M3 Blade Servers

Virtual Emulex Adapter Card for Cisco UCS B420 M3 Blade Servers

SuperCap module for Cisco UCS B420 M3 Blade Servers

NO.82 Which data center type allows a company to lease the equipment and infrastructure?

colocation data center

managed services data center

enterprise data center

green technology data center

NO.83

Refer to the exhibit. Which item does F represent?

HDD 1

TFP Module

SuperCap Module

CPU 2

CMOS Battery

NO.84 Which three firmware components does the Host Upgrade Utility upgrade? (Choose three.)

Fabric Interconnect firmware

LAN on Motherboard

Cisco UCS Manager

CIMC

System BIOS

NO.85 Which ANSI/TIA-942 data center tier provides up to 99.982% uptime availability per year?

basic site infrastructure

redundant-distribution site infrastructure

redundant-capacity component site infrastructure

concurrently maintainable site infrastructure

NO.86 Which command-line interface mode is best described by this prompt?
UCS-switch-A (nxos)#

maintenance mode

EXEC mode

local management mode

global configuration mode

Cisco IOS mode

NO.87 Which cable is used to access the command-line interface of a Cisco UCS 6120XP Fabric Interconnects?

KVM cable

console cable

Ethernet cable

SFP+ Ethernet transceiver cable

NO.88 Refer to the exhibit.

Which two faults can occur if the System Health LED is in a steady amber state? (Choose two.)

At least one DIMM is faulty.

Major fault with CPU

Major fault with the system board

CPU mismatch

Major fault with memory DIMM

NO.89 Refer to the exhibit.

Which item does D represent?

Pin icon (prevents Navigation pane from sliding)

Favorite icon (make any specific work pane in the application as your favorite)

To view the Navigation pane

Index Icon (view listing in alphabetical order)

NO.90 Refer to the exhibit.

Which item does A represent?

Emulex Adapter Card for Cisco UCS B420 M3 Blade Servers

Virtual Interface Card for Cisco UCS B420 M3 Blade Servers

mLOM for Cisco UCS B420 M3 Blade Servers

Virtual Emulex Adapter Card for Cisco UCS B420 M3 Blade Servers

SuperCap module for Cisco UCS B420 M3 Blade Servers

NO.91 Refer to the exhibit.

Which Cisco MDS chassis supports the 48-Port 16-Gbps Fibre Channel Switching Module?

MDS 9509

MDS 9513

MDS 9710

MDS 9506

NO.92 Refer to the exhibit.

Where is the best place to see the power supply status of the blade server enclosure?

A – Chassis 1

B – Chassis 1 – PSUs

C – Chassis1 – Servers

D – Rack-Mounts – Servers

E – Fabric Interconnects A – PSUs

NO.93 Which two statements about DIMM replacement in Cisco UCS Servers are true? (Choose two.)

In blade servers, DIMMs can be installed in either 1, 2, 4, or 8 DIMMs per channel.

Rack-mount and blade servers have memory fault LEDs that indicate which DIMM requires attention.

In servers that require pairs of DIMMs, the pairs must be identical (manufacturer, size, part #, and so on).

If the memory in a server is not fully populated, you can install DIMMs in any open slot.

NO.94 On which three devices can the Host Upgrade Utility be performed? (Choose three.)

C420

C230

B230

B210

C210

B460
G: C240

NO.95 What are two descriptions for PCle? (Choose two.)

The PCle 4.0 standard doubles the transfer rate compared to PCle 5.0.

The PCle supports native hot-swap functionality.

A link that is composed of four lanes is called an x4 link.

The PCle standard is a bus-based system in which all the devices share the same bidirectional, 32-bit or 64-bit, parallel signal path.

A PCI Express x16 adapter can be installed into an x4 slot.

NO.96 Which two statements about PCIe are true? (Choose two.)

The PCIe link is built around dedicated unidirectional couples of serial, point-to-point connections known as lanes.

You can install a PCI Express x8 adapter into an x4 slot.

The PCIe standard is a bus-based system in which all the devices share the same bidirectional, 32-bit or 64-bit, parallel signal path.

The PCIe 1.0 standard doubles the transfer rate compared to PCIe 2.0.

A link that is composed of four lanes is called an x4 link.