[Q378-Q400] Certification Training for 200-301 Exam Dumps Test Engine [2025] : Free Exams Dumps Materials : http://exams.dumpsmaterials.com

NO.378 Which virtual MAC address is used by VRRP group 1?

0000.5E00.0101

0500.3976.6401

0050.0c05.ad81

0007.c061.bc01

NO.379 Which state is bypassed in Rapid PVST+ when PortFast is enabled on a port?

blocking

forwarding

learning

discarding

NO.380 전시회를 참조하세요.

Router R2 is configured with multiple routes to reach network 10 1.1 0/24 from router R1. What protocol is chosen by router R2 to reach the destination network 10.1 1 0/24?

eBGP

static

OSPF

EIGRP

NO.381 Refer to the exhibit. Which Command do you enter so that R1 advertises the loopback0 interface to the BGP Peers?

Network 172.16.1.32 mask 255.255.255.224

Network 172.16.1.0 0.0.0.255

Network 172.16.1.32 255.255.255.224

Network 172.16.1.33 mask 255.255.255.224

Network 172.16.1.32 mask 0.0.0.31

Network 172.16.1.32 0.0.0.31

NO.382 What is a recommended approach to avoid co-channel congestion while installing access points that use the
2.4 GHz frequency?

different nonoverlapping channels

different overlapping channels

one overlapping channel

one nonoverlapping channel

NO.383 전시회를 참조하세요.

What does router R1 use as its OSPF router-ID?

10.10.1.10

10.10.10.20

172.16.15.10

192.168.0.1

NO.384 How does a DHCP server dynamically assign IP addresses to hosts?

Addresses are permanently assigned so that the host uses the same address at all times

Addresses are assigned for a fixed period of time. At the end of the period, a new request for an address must be made, and another address is then assigned.

Addresses are leased to hosts. A host will usually keep the same address by periodically contacting the DHCP server to renew the lease.

Addresses are allocated after a negotiation between the server and the host to determine the length of the agreement.

NO.385 Which three features are added in SNMPv3 over SNMPv2?

Message Integrity

압축

인증

암호화

Error Detection

NO.386

Refer to the exhibit. How does router R1 handle traffic to 192.168.10.16?

It selects the IS-IS route because it has the shortest prefix inclusive of the destination address.

It selects the EIGRP route because it has the lowest administrative distance.

It selects the OSPF route because it has the lowest cost.

It selects the RIP route because it has the longest prefix inclusive of the destination address.

NO.387 전시회를 참조하세요.

An administrator configures four switches for local authentication using passwords that are stored in a cryptographic hash. The four switches must also support SSH access for administrators to manage the network infrastructure. Which switch is configured correctly to meet these requirements?

SW1

SW2

SW3

SW4

NO.388 전시회를 참조하세요.

Which switch becomes the root of a spanning tree for VLAN 20 if all li links are of equal speed?

SW1

SW2

SW3

SW4

NO.389 전시회를 참조하세요.

An engineer is tasked with verifying network configuration parameters on a client workstation to report back to the team lead. Drag and drop the node identifiers from the left onto the network parameters on the right.

NO.390 전시회를 참조하세요.

An administrator must turn off the Cisco Discovery Protocol on the port configured with address last usable address in the 10.0.0.0/30 subnet. Which command set meets the requirement?

interface gi0/1
no cdp enable

interface gi0/1
clear cdp table

interface gi0/0
no cdp advertise-v2

interface gi0/0
no cdp run

NO.391 전시회를 참조하세요.

After the election process what is the root bridge in the HQ LAN?

Switch 1

Switch 2

Switch 3

Switch 4

NO.392 전시회를 참조하세요.

Which configuration allows routers R14 and R86 to form an OSPFv2 adjacency while acting as a central point for exchanging OSPF information between routers?

NO.393 Which action does the router take as rt forwards a packet through the network?

The router replaces the source and desinaoon labels wth the sending router uterface label as a source and the next hop router label as a desbnabon

The router encapsulates the source and destination IP addresses with the sending router P address as the source and the neighbor IP address as the destination

The router replaces the original source and destination MAC addresses with the sending router MAC address as the source and neighbor MAC address as the destination

The router encapsulates the original packet and then includes a tag that identifies the source router MAC address and transmit transparently to the destination

NO.394 전시회를 참조하세요.

Based on the LACP neighbor status, in which mode is the SW1 port channel configured?

패시브

mode on

auto

활성

NO.395

Three switches must be configured for Layer 2 connectivity. The company requires only the designated VLANs to be configured on their respective switches and permitted accross any links between switches for security purposes. Do not modify or delete VTP configurations.
The network needs two user-defined VLANs configured:
VLAN 110: MARKETING
VLAN 210: FINANCE
1. Configure the VLANs on the designated switches and assign them as access ports to the interfaces connected to the PCs.
2. Configure the e0/2 interfaces on Sw1 and Sw2 as 802.1q trunks with only the required VLANs permitted.
3. Configure the e0/3 interfaces on Sw2 and Sw3 as 802.1q trunks with only the required VLANs permitted.

NO.396 A network engineer is replacing the switches that belong to a managed-services client with new Cisco Catalyst switches. The new switches will be configured for updated security standards, including replacing Telnet services with encrypted connections and doubling the modulus size from 1024. Which two commands must the engineer configure on the new switches? (Choose two.)

crypto key generate rsa general-keys modulus 1024

transport input all

crypto key generate rsa usage-keys

crypto key generate rsa modulus 2048

transport Input ssh

NO.397 전시회를 참조하세요.

An engineer is configuring the router to provide static NAT for the webserver Drag and drop the configuration commands from the left onto the letters that correspond to its position in the configuration on the right.

NO.398 Which HSRP feature was new in HSRPv2?

VLAN group numbers that are greater than 255

Virtual MAC addresses

tracking

preemption

NO.399 전시회를 참조하세요.

Which switch becomes the root bridge?

S1

S2

S3

S4

NO.400 An engineer needs to add an old switch back into a network. To prevent the switch from corrupting the VLAN database which action must be taken?

Add the switch in the VTP domain with a lower revision number

Add the switch with DTP set to dynamic desirable

Add the switch in the VTP domain with a higher revision number

Add the switch with DTP set to desirable