Actual 300-510 Exam Recently Updated Questions with Free Demo [Q135-Q150]

QUESTION 135
Refer to the exhibit.

Which task must you perform on interface g1/0/0 to complete the SSM implementation?

QUESTION 136
Refer to the exhibit.

A network operator must inject a Level 1 route from XR2 (10.16.16.0/24) into the ISIS topology. Which configuration allows the injection in a way that XR3 and XR1 have a valid and working route for 10.16.16.0/24?

QUESTION 137
Refer to the exhibit.

Router 1 has established an SR-TE tunnel with router 2. Which statement describes this configuration?

QUESTION 138
Refer to the exhibit. Which effect of this configuration is true?

QUESTION 139
Refer to the exhibit.

An engineer is troubleshooting an OSPF issue. Router 1 has a neighbor relationship with router 2. Only router 1 classful EIGRP routes can be seen on router 2. In order for all EIGRP routes to be redistributed correctly, which action should be taken?

QUESTION 140
Refer to the exhibit. A network consultant is updating the company’s MPLS solution and configuring several new PE devices to enable full communication among PE devices connected to the network. The updates must ensure the redundancy and scalability of the network. The egress LSR is configured with mpls Idp explicit-null While configuring the given PE router to be adjacent to the egress LSR. The consultant notices that MPLS forwarding is not working in the network.
Which action resolves the issue?

QUESTION 141
What is a key benefit of BGP dynamic update peer groups?

QUESTION 142
Refer to the exhibit. After a recent network implementation project, customer A is performing stress testing to verify network redundancy at the branch office connected to R4. When the link from R2 is shut down as shown, the SLA tracking object fails and the cost of the link between R2 and R4 increases to 100. However, a traceroute operation from a PC in the branch office shows that traffic to HQ is still routed via R2. Which solution corrects the problem and optimizes traffic flow via R3 without creating operational overhead?

QUESTION 143
Refer to the exhibit. A network engineer commissioned Router 1, which connects to Router 2 and Router 5. Router 1 participates in IS-1S routing with other routers, but it is not used for transit traffic. Traffic from Router 2 to Router 5 is expected to travel via Router 1, but the traffic is travelling via Router 3 and Router 4. Which action resolves this problem?

QUESTION 144
Refer to the exhibit. Router 1 is connected to router 2 on interface TenGigE0/1.
Which interface provides the alternate path to 172.16.200.9/32 when the link between router 1 and router 2 goes down?

QUESTION 145
Refer to the exhibits.

All links inside the network are configured at a default cost of one inside the fully converged OSPF domain. Given the configuration from XR1, which interface does traffic from XR1 that is destined to the loopback interface of XR6 select for the exiting interface?

QUESTION 146
Refer to the exhibit. A regional service provider provides connectivity for a growing enterprise, which recently acquired a new location in a nearby city. The new location, which is connected at CE2. requires connectivity to the company’s data center, which is connected to CE1. The service provider will use VPNv4 to connect the two locations. The networking team is planning to implement segment-routing traffic engineering to route traffic from PE1 to PE2 over a delay- optimized path through P2. Which action must the engineering team take to begin the implementation?

QUESTION 147
Which statement about BFD on Cisco IOS XR Software is true?

QUESTION 148
Refer to the exhibit.

Refer to the exhibit. A network engineer is configuring router R3 to handle multicast streams, but Host-2 cannot send subscriptions messages to the IPTV source. Which configuration must the engineer apply to router R3 so it passes the IPTV stream to Host-2?

QUESTION 149
What is one of the purposes of a default Multicast Distribution Tree?

QUESTION 150
A network engineer must configure a Cisco IOS XR router with BGP dampening.
Which configuration meets these parameters?